SES battery,VRLA/SLA battery
 
Home Company Products Tech Support Services Contact  
Support
Battery Introduction
Battery Glossary
Operation Manual
Battery Safety
Battery Terminal
VRLA Battery FAQ
MSDS
  Home > Support > Battery Glossary
Battery Glossary
VRLA -Valve regulated lead acid battery.
SLA -Sealed Lead-acid
UPS-Uninterruptible Power Supply
CCV -Closed - circuit voltage.
OCV -Open - circuit voltage
Pb -Chemical symbol for lead.
Ah -Amp hour. The unit of battery capacity
EOD -End of discharge.
20hr Rate -The capacity a battery will deliver over 20hrs
Definitions
ABS RESIN
A Plastic material largely used for the case and cover of batteries.
ACTIVE MATERIAL
The substance which electrochemically reacts in the electrode of batteries. Lead-acid batteries adopt lead dioxide for the positive electrode and spongy lead for the negative electrode.
AMBIENT TEMPERATURE
Average temperature in the vicinity of the battery.
AVAILABLE CAPACITY
The capacity actually available from a cell/battery. The available capacity is the capacity when it discharges at a specified hour rate, and expressed in hour rate and Ah.
BOLT FASTENING
A type of battery terminals, to which lead wires are connected with bolts.
BUILT-IN THERMOSTAT
The built-in thermostat is a reset table switch built in a battery for temporarily cut off the battery circuit when the temperature of the battery exceeds a preset values or when the battery charge/discharge at a higher rate than predetermined.

CAPACITY
The electric capability of a battery. It usually means ampere-hour capacity expressed in Ah or C(coulomb).
CELL
The minimum battery unit which composes a storage battery. Nominal voltage of the cell of the lead-acid battery is 2V.
CHARGE
The operation of supplying a battery with a DC current from an external power source to have the electrode active material conduct chemical reactions then to store electric energy as chemical energy in the battery.
CHARGE ACCEPTANCE
Test of batteries to check whether or not they are adequately recharged after discharge.
CHARGING EFFICIENCY
General term for ampere-hour efficiency and watt-hour eficiency. In many cases, however,it means the ampere-hour efficiency.
CONSTANT CURRENT CHARGE
A method of charging: to charge a battery with a constant current.
C-RATE
A charge or discharge current rate expressed in A or mA.It is numberically the same as the hour rate capacity of a battery expressed in Ah of the rated capacity.
CUT-OFF VOLTAGE OF DISCHARGE
The terminal voltage of a battery at which discharging should be discharging should be discontinued. This voltage depends on discharge current, type of electrodes and construction of battery.
CYCLE LIFE
The number of charge/discharge/rest cycles a cell/battery can provide. Cycle life is usually expressed by the number of cycles available before duation of discharge decreases to a half of the initial value.
DEPTH OF DISCHARGE
A value to express the state of discharge of a battery. The depth of discharge is generally expressed by the ratio of discharge amount to rated capacity of the battery.
DISCHARGE
To draw off the electric energy stored in a cell/battery.
DISCHARGE RATE
The term to express the magnitude of discharge current. When assuming discharge current and time to discharge cut-off voltage t hours, this discgarge is called t-hour rate(tHR) discharge, and the current is called t-hour rate diacharge current. When time t is minutes instead of hours, tMR is used.
DUTY CYCLE
Test of batteries in ordinary use including charge, discharge and rest.
ELECTROLYTE
The medium which serves to conduct ions in the electrochemical reactions in batteries. The lead-acid battery adopts diluted sulfuric as the electrolyte.
ENERGY DENSITY
Energy available per unit Approx. mass or unit volume of a cell/battery. Energy desity is expressed in Wh/kg or Wh/l.
FLOAT CHARGE
The system in which a constant voltage is continuously applied to a battery connected to a rectifier in parallel with a load to maintain the battery in charged state: on occurrence of power failure or load variation, the battery supplies power to the load without any short break.
GAS RECOMBINATION ABILITY
Capability of a battery to recombine (or absorb) internally generated oxygen gas at the negative plate. The greater this capability is, the larger the available charge current.
HIGH RATE DISCHARGE
A very rapid discharge of a battery. (in many cases it means discharging at approx.1 CA or higher rate.)
INTERNAL PRESSURE
The pressure within a sealed battery. Internal pressure of a battery is increased by oxygen gas which is generated from the positive plate at the end of charging.
INTERNAL RESISTANCE
The resistance within a battery; it is the total of individual resistances of the electrolyte and the positive and negative plate. Internal resistance is simply measured with the current four-terminal method(1,000Hz) and expressed in the composite value of resistance component and capacitor component.
INTERNAL SHORT-CIRCUIT
Touching of the positive and negative plates within a call.
LIFE
The time period until a cell/battery loses its expected characteristics.
LOW MAINTENANCE
Low maintenance means that no watering norequalizing charge is requireed in operating batteries.
LOW-VOLTAGE CUT-OFF
A circuitry designed to discontinue discharge of a battery at a predetermined voltage level.
MALE TAB
The matallic pieces which are attached to a SLA battery as the terminals.
MEMORY EFFECT
A phenomenon where a temporary drop of discharge voltage is observed during deep discharge of an alkaline rechargeable battery which has been subjected to shallow charge/discharge. Cycles or trickle charging over long time.

NEVIGATIVE PLATE
The battery electrode into which a current from the external circuit flows during discharging. The negative plate has lower electric potential than the positive plate to the electrolyte. The negative plate is incorporated with connection parts such as the electrode pole.
RATED CAPACITY
A nominal value of capacity of a cell/battery, which is a measure of electric capability. Rated capacity is rather approximate compared with rated capacity.
NOMINAL VOLTAGE
A nominal value to indicate the voltage of a cell battery. Generally, nominal voltage value of a battery is somewhat lower than its electromotive force. Nominal voltage of the lead-acid battery is 2.0 V per unit cell.
OPEN CIRCUIT VOLTAGE
Measured voltage of a cell/battery which is electrically disconnected from the external circuit.
OVERCHARGE
Continuted charging of a fully charged cell/battery. With batteries which require watering, overcharge causes electrolysis of water, resulting in rapid decrease of electrolyte. Generally, overcharge adversely influences battery life.

OVERDISCHARGE
Discharge of a battery to a voltage below a predetermined cut-off voltage.
PARALLEL CHARGE
Simultanous charging of two or more batteries connected in parallel. In cyclic use of batteries, specifically, the parallel charge tends to cause an imbalance in charge state among the batteries, which may shorten their service life.
POLYPROPYLENE RESIN
A plastic material which is often used for the case and cover of batteries.
POSITIVE PLATE
The battery electrode from which a current flows to the external circuit during discharging. The positive plate has higher electric potential than the negative plate to the electrolyte. The positive plate is incorporated with connection parts such as the electrode pole.
QUICK CHARGE(RAPID CHARGE)
Charging in a short time with a large current.
RATED CAPACITY
The stated capacity of a battery; namely, the ampere-hour amount can be drawn from the battery in fully charged state at a specified temperature, at a specified discharge rate, and to a specified cut-off voltage. The symbole CN may be used to express the rated capacity of N-hour rate.
RECHARGEABLE BATTERY
The rechargeable battery is a system comprising two different electrodes and ion-conductive medium, which is capable of converting chemical energy to electric energy, and vice versa. It is also called a secondary battery.
REFRESH CHARGE(AUXILIARY CHARGE)
Charging ogf a battery mainly to compensate for its self discharge.
RESIDUAL CAPACITY
Residual capacity of a battery after partial discharge or after storage for long time.
RETAINER TYPE
A method to control flowing electrolyte in a battery with the retainer mat,etc..
REVERSE CHARGE
Charging of a battery with its polarity reversed. Namely, the battery discharges.
SELF DISCHARGE
Reduction in capacity of a battery while no current is draw by the external circuit. Self discharge depends on temperature: amount of discharge approximately doubles by each (10¡ãC) rise of ambine temperature.
SEALED LEAD-ACID BATTER(SLA BATTERY)
Valve-regulated lead-acid battery.
SEPARATOR
A porous or microporous liquid-absorbent material which is installed between the battery electrodes for preventing short-circuit, securing the separation of the electrodes and retaining electrolyte. The separator should be resistant to oxidation and chicals; it should excel in electric insulation and liquid-retention;and it should not disturb diffusion of the electrolyte and ionic conduction.
STANDBY USE
General term of constant stand-by battery systems. Batteries are kept charged by trickle/float method at all times in preparation for unforeseen power disruptions.
TERMINAL VOLTAGE AT DISCHARGE
The voltage of a battery during discharge.
THERMAL RUNAWAY
Such phenomena as an excessively high set-up voltage in constant-voltage charging of a battery and a very high battery temperature cause charge current to increase,which than raises the termperature further:this vicious cycle is called thermal runaway,which may,in the worst case,result in breakage of the battery due to heat.
TRICKLE CHARGE
To charge a battery in the state of disconnection from the load to compensate for its self discharge.
TRICKLE LIFE
The service life of a battery in the trickle use. Usually,the trickle life is the time expressed in years before the dischargeable time of the battery decreases to a half of the initial value.
Equipment or system which is automatically connected to the load to supply power if the main power fails.
VALVE(ONE WAY VALVE)                                                                              
a valve on each battery which automatically releases gas from the battery when internal pressure of the battery exceeds a predermined value:it prevents breakage of the battery due to excessive internal pressure caused by the gas generated by charging or other reasons. The valve also serves to prevent outside air from entering batteries.
Copyright ©2011-2016SES Battery All Rights Reserved.
TEL£º+86 755 2831 9197  FAX£º+86 755 2831 9197  E-mail£ºsales@sesbattery.com